- Knowledge Base
- IC Realtime
- SmartPSS
-
Dahua
- Videos
- PTZ
- Quick Start Guide
- Abnormal Alarms
- Face Mask Detection
- Alarms
- Smart Motion Detection
- IVS - Perimeter Protection
- DMSS
- Audio
- Invalid Camera Format
- IPC Reset
- Backup Video
- Intercoms
- ITC - ANPR
- Face Detection
- Push Notifications
- Milestone
- SmartPSS
- Password
- HDCVI Camera
- TiOC S4
- Troubleshooting
- RTSP
-
IC Realtime
-
C2Max
-
TP Link
-
Uniview
-
Satel
IC Realtime - SmartPSS - Accessing the Web Interface Using Smart PSS
It is possible to use SmartPSS to "pivot" to the web interface of IC Realtime devices such as NVR's, XVR's and IP Cameras, follow the guide below to see how
- Access the Smart PSS application and navigate to the Device CFG section.
- Choose your device on the left hand panel
- Select Link to WEB.
Note: This will only work for devices added by P2P or local IP address. Port Forwarding of the TCP and HTTP ports is required if not using P2P and the device is in a remote location from your SmartPSS instance