Dahua - Intercoms - How to add VTO to VTH via Configtool

This article will go over the setup a VTO with Dahua Indoor Monitor by using Configtool software.

Step by Step Instructions

1. Once devices are initialized go to Building Config

2. Go to Global Parameter

3. Global Parameters

Global Parameter
Center Number = Leave Default	Server Type = VTO
Sever Address = Main VTO IP Address	Server Port = 5060
Sever Username = Recommended to match VTO username	Sever Password = Recommended to match VTO password
Sip Domain = VDP	Register PWD = Leave Default
VTO Username = Enter VTO username	VTO Password = Enter VTO password
VTH Username = Enter VTH username	VTH Password = Enter VTH Password

Enter the information by following the table above. Click on OK to proceed

4. Create a project by clicking on Add Node

5. Select the amount of Floors and Rooms will be added to the project. In this guide we will only have 1 floor with 1 room with 0 extensions for each room. Click on OK

6. Check serial number of the Main VTO and the Project entry and click on Association. This will link the Main VTO with the project entry

7. Do the same with the VTH

8. Once all the devices are associated click on Association List

9. Check all the devices and click on Config

10. Configtool will do the rest to configure the devices. Once they reboot the configuration is done